Set of 2 forks seals and 2 dust seals for many of the late 70''s Honda''s as well as a other makes. When replacing fork seals be very careful not to scratch or gouge the aluminum during the removal of the old seals. Use a fork seal driver to install the new seals. Be sure to drive it in evenly and make sure it fully seats so the snap ring can be installed. If you''re unsure if your forks are stock please check the fork seal dimensions.The old dust boots become stiff and start to crack over time, keep dirt and water off your fork seals with a fresh pair of boots!
These are high quality reproduction seals produced in Taiwan. When it comes to rubber parts and seals it''s generally better to install a brand new part instead of using a NOS part which has hardened due to age.
Fork Seal:
Inner Diameter: 35mm
Outer Diameter: 48mm
Height: 11mm
Material: NBR (Nitrile)
Dust Seal:
Top Opening ID: 35mm (1.4")
Bottom Opening ID: 53.5mm (2.1")
Overall OD: 60mm (2.35")
Overall Height: 30.5mm (1.2")
Inner Lip 5/8 before it starts to taper in (measured from the bottom)
Fits Honda:
CB500T Twin DOHC - 1975-1976
CB550F Super Sport - 1977
CB550K Four - 1977-1978
CB750A Hondamatic - 1976-1978
CB750F Super Sport - 1975-1976
CB750K Four - 1977-1978