The Mamorubot Polypropylene Build Plate is a 3d printer build plate to be used instead of glass, mirror beds or adhesive surfaces. ,it is a build plate offer consistent and reliable prints.
Can be attached directly to your glass bed using clips or tape.
How to use your new polypropylene build plate ? ..
Note: the polypropylene build plate with different properties comparing to a glass or mirror plate, when install the plate, to avoid damage, please follow up steps as bellow .
1) Remove old build plate .
2) Make sure bed is level and flat in all directions .
3) Install your new polypropylene build plate and make sure it is securely fastened to the print bed. .
4) If your printer with heated bed, please heat bed to normal operating temperature for 5 minutes so the new plate well heated .
5) When bed is heated, double check for flatness..
6) Due to differences in plate thickness, please adjust the distance of nozzle to new plate to a proper height, usually about a thickness of A4 paper
7) Make print test to verify proper adhesion according to different material , the reference temperatures are as bellow .
Temperature settings for different filaments: .
1. PLA:50-70℃.
2. Flexible filament: 50-70℃.
3. ABS:100-125℃ ( 110℃ is recommended ).
4. PC:100-130℃ ( 120℃ is recommended ).
5. Nylon:90-120℃ ( 110℃ is recommended ).
6. PETG: 50-70℃.
8) 、This Large size (470mmX470mm) is for CR-10 Max to use, due to size too big,may require additional adjustments to the temperature..
9)When printing with good adhesion and easy to remove the printed item, means leveling and temperature adjusting well done,
Note: If you see reduction in adhesion, please clean with Isopropyl alcohol and a clean cloth..
If the platform not flat,can contact customer service to get replacement..