مميزات خاصة

This Water Electrolyzer is very easy to operate, quick test and obvious results. It provides the simplest and cheapest way to test water quality. Look at your drinking water situation
Test method: Prepare two glasses of transparent water (100 to 150 ml); one glass of tap water and another glass of water. Put the metal pillars in two cups, open and start the test, after 30-60 seconds, turn it off and remove the water cell
CAUTION: Avoid electric shock when using it. Do not touch the lever when the electrostatic precipitator is inserted into the power outlet
Note: The electrolyzer can only prove the presence or absence of impurities, not the quality of the water quality.TDS value>300ppm, not suitable for electrolysis experiments
Plug standard: 2(US plug);Line length: 80cm/31.5";Net weight: about 90g;Packages: 1 x Water Quality Testing Electrolyzer;2 x Iron Bars;2 x Aluminum Bars

وصف

Usage method:
1. Prepare test water: take two transparent glasses with a capacity of 100-150 ml, one containing ordinary water (tap water), the other containing pure water or distilled water, and discharge them on the table. Then use TDS pen to test the TDS value of these two glasses of water. If the TDS value is greater than 300ppm, it is not suitable for electrolysis experiment
2. Preparation for inspection: put two groups of iron and aluminum rods into two glasses, the water level is close to the heel of the iron and aluminum rods, and then plug in the power supply
3. Inspection: press the power switch button on the electrolyzer to the on position to start the inspection
Note: pay attention to the electrolysis time, usually about 15 ~ 60 seconds. At the end, press the power switch to the off position, unplug the power supply, and finally take out the electrolyzer. Clean the iron rod and aluminum rod in time

مرحبًا،

بحث

SaiDian 1 قطعة المياه الكهربائي اختبار التحليل الكهربائي الحديد القضبان TDS تستر متر سريعة المياه جهاز اختبار جودة الماء نقاء المياه تصفية أداة قياس

مميزات خاصة

وصف

منتجات شبيهه