Pulley Machine Cable Ball Stopper Replacement, Wearable Nylon Ball Stop for Cable Machine Gym Machine Smith Machine Weight Lifting Cable Ball Terminal (2 Ball-Sets)

USER INSTRUCTION:
-For a new cable, use cable to go through the hole of ball (and set other parts in right position if there are), peels a small section of plastic cover (if there is) of the cable. when connect it to a metal eyelet terminal, use a hydraulic crimper (plier) tool to squeeze the connecting part.
--if you don't use a eyelet terminal, but make the cable with a loop end, you can use a wire rope clamp or crimping loop sleeve on the cable to fasten it. you need a spanner or hydraulic crimper to process it.
- For an old cable, firstly you need to cut off the end of the cable (where there is a eyelet or loop terminal), then use cable to go through the hole of ball (and set other parts in right position if there are), and process it just same as a new cable we mentioned above.

Q&A from users
- Q: How to install the ball stopper?
- A: This is mostly for use with a new cable. The cable has to be went through the hole of the ball. Since most cables have loops at their ends, to install this on a cable that's already in service, you'd have to cut the loop off. But then the cable wouldn't be serviceable. You can get the cable and end-fittings from Home Depot, so replacing most cables is pretty easy.
- A: In my case, I had to remove the existing cable from the machine by unbolting the cable from where it was attached to the frame. I then threaded the new rubber stopper onto the cable and then ran the cable through the pulley system and back to where I had removed the cable from the frame of the machine.