LENS REPLACEMENT INSTRUCTION
1. Open the holding Clips (two on the top and two on the bottom) by pulling away from the frame to remove the old lens.

2. Insert the new lens into the lens slot at both ends. Put the top of the lens into the lens groove. Make sure the holes are in line with the pins and close the two holding clips.

3. Put the lower part and the nose part of the lens into the lens groove, make sure the holes are in line with the pins, and close the holding Clips.

4. It may be necessary to stretch the frame slightly to install the lens. At the end make sure the four clips are closed.

CLEANING INSTRUCTIONS
To clean your lens, remove the lens from the frame and wash it gently using soap and running water.
The lens should be air-dried as much as possible before being gently wiped with a soft, clean cloth and replaced in the frame.
Please do not use chemical cleaners to treatments on your lens.

AX-SLDMT GOGGLES
1. No injuries will be caused by sharp edges or protruding elements on the goggles.

2. The eyes will be protected against harmful UV rays.

3. The motor-sport goggles' correct fitting of the adjustable head strap- will protect against draught (airflow), dust, gravel, and humidity.

4. Sufficient air circulation is guaranteed through the foam-covered opening.