Instructions:
1. Connect the bottle to the helm water tank (don't pierce the bottle and don't let the bottle empty).
2. Connect the bridge tube to the drain joint on the steering cylinder and loosen the joint.
3. Use the rudder to pump fluid through the system by turning the wheel in one direction.
The bubbles will be pushed to the helm of the reservoir.
4. Through the fully articulated joint, manually swing the outboard motor to release the
trapped air, and confirm the good air-out.
5. Note: Position the discharge fitting upward when pumping fluid with the rudder pump, it will allow air to be out from the cylinder.
6. Repeat step 3 and step4 as needed until no air can be seen in the bridge tube.
7. Tighten the drain joint before removing the bridge tube.