The following components are supplied with this Universal Kit:
1 x Stainless steel mounting bracket. To mounted within the Engine Bay that will be Always Above the Water Level.
2 x Galvanized self tapping screws for mounting the bracket.
4 x O-ring sealed bulkhead fittings.
4 x Breather / filters
5 x O-ring sealed water-resistant push fittings, incl Y fitting.
4 x Brass hose barbs / male - for easy connection to existing factory breather hose / lines if required.
15 x Cable ties, UV resistant.
10 x Meters 6mm-OD hose.
2 x Corrugated protective sleeves 1 meter total combined length, to enclose breather hose at cable tie points if needed.
5 Years Warranty.
Installation Tips:
Due to difficulty in locating gearbox & transfer case breather positions on all vehicles this kit is to be installed by a qualified mechanic / workshop that has a hoist with safety equipment available.
Some transfer cases, gearbox's & diff housings will not have a threaded fitting for removal, they will have a pressed-in top cover / hat breather vent installed,
in these cases a mechanic must install this kit as they will need to modify the pressed in top cover / hat breather to allow rubber hose to be connected and then allowing connection to your diff breather kits hose / fittings / brass hose barbs.
Please note additional components may be required to install this kit depending upon your vehicle application & series.
Please note diff breather kits are to be installed by licenced workshop that has access to a hoist with safety equipment available.