Specification:
1. Interface: 2X LAN Ports
2. Standards and protocols: Wi-Fi 802.11g, Wi-Fi 802.11n, Wi-Fi 802.11b, 802.11ac
3. Three mode: Repeater Mode/AP Mode/Router Mode

Multiple Functions:
Repeater Mode: Extend WiFi coverage of an existing wireless network;
Wireless Access Point Mode: Convert a wired network to a wireless network;
Wireless Router Mode: Create an instant private wireless network.

Easy setup in 4 steps：
1. Plug the extender into a power outlet near your router. Wait about 20s until the first power-on light of the Repeater slowly flash;
2. Go to your phone's WiFi connection page and select "Repeater-XXX" to connect. (If you can't find the name of the repeater WIFI, it is recommended to turn on Airplane Mode on your phone and then turn off Airplane Mode.) ；
3. Connect to "Repeater-XXX" and then jump directly to the browser page to set the WIFI information of the repeater, note that the repeater password set inside needs to be the same as the router's WIFI password!!! If you can't jump automatically, enter 192.168.11.1 in this browser;
4. If it still doesn't work, there is another way, you can plug in the Internet cable through the computer and enter the IP address (192.168.11.1) on the computer browser to configure.

Note:
The passwords of your repeater are as same as your router.
More than 70% signal is recommended for the most reliable connection.
Poor signal connection may cause slow speeds or dropped connection.
If do not see desired wireless network, you can move the range extender closer to the router and scan again as it may be out of range.
The Extender mode of this device can be set up by wireless device such as smart phone or laptop.