This universal hydraulic clutch master cylinder rod system is designed for use with most motorcycles.Constructed from aluminum, it has a total length of 140mm and a thread size of M10x1.25mm.The system supports efficient hydraulic fluid transfer to maintain consistent function in clutch and brake operations.To bleed the hydraulic clutch system, fill the reservoir completely to prevent air bubbles.Attach the tubing to the bleed screw without fully tightening so that the side holes remain exposed.Connect the pump to the tubing and position the oil cup at an elevated height.Operate the pump handle approximately ten times, then wait 5 to 10 minutes until fluid flows from the bleed screw hole.Once fluid appears, tighten the screw to complete the bleeding process.To verify proper bleeding, push the pump lever toward the body while holding the handle; the handle should move about 3 cm before meeting resistance, indicating correct setup.the wire is fully extended and secured during installation with the clutch handle in a relaxed position.Package includes one hydraulic clutch master cylinder assembly.Actual product color may vary slightly due to screen display differences.