The main tub seal is located between the transmission and the outer tub. Its the primary water seal in the outer tub for the transmission-shaft. If your washer is leaking during the fill cycle, or at agitation time, your tub seal may need to be replaced. You can check if the tub seal needs to be replaced by watching that area during an actual fill cycle. Take off the front panel, or if it is a front-loading washer, the rear panel. Without touching the washing machine, observe the place where the shaft of the transmission comes into the tub and the weep holes at the housing of the rear bearing. If there is water leaking, the tub seal is at fault. NOTE: This seal is difficult to replace and should probably be installed by a qualified technician.
Compatible brands include:
General Electric Fits Models
GCWP1805D1CC , GHWN4250D0WW , GHWN4250D1WW , GIWN3000M0WW , GIWP1000M0WW , GIWP2000M0WW , GMAN4250F1WS , GMAN5650D0WW … Replaces the following part numbers:
AP5645738, WH02X10032, WH02X1196, WH2X1196 Fixes problems with:
1. Leaking
2. Noisy
3. Marks left on clothes
4. Pumps but will not spin Please reach out to us if you have a question about compatibility. Comment below in the customer questions and answer section or send us a message on the Seentech storefront. We're happy to help ensure you select the right part number for your Washer