AP03 Input Shaft Bearing Puller Tools Kit 4308011 for Fuller 1 3/4″ & 2″ Shafts Works with Fuller input shaft bearing pullers for 1 3/4″ and 2″ shafts.Not compatible with RT600 or 6600 series transmissions.Designed to remove the head shaft bearing quickly and simply without damaging the drive gear teeth.Constructed from steel with a black finish for strength, corrosion resistance, rust resistance, and hardness.Includes: 1 x Puller Tool 1 x Screw 2 x Snag Ring 1 x Close Ring Installation steps: 1.Use forceps to remove the outside ring.2.Position the puller tool onto the transmission shaft.3.Install the snag rings between the notch and the puller tool.4.Use the close ring to secure the snag ring.5.Tighten the screw using a ratchet or wrench (not included).6.Pull the puller tool until the bearing is loosened.