Specification:
Item Type: Satellite Finder Meter
Material: ABS
Frequency range: 950-2150MHz
Power supply voltage: 13-18V DC
Input Level Range: -40dBm-10dBm
Operating Temperature: 0-40℃
Impedance: 75 ohms

How to use:
1. Turn on the satellite receiver, the satellite finder will turn on automatically.
2. Set the to the correct azimuth and elevation angles (related information should be provided with the satellite dish).
3. Adjust the knob until the signal strength shows 0% (threshold point).
4. Slowly move azimuth and elevation angles to reach maximum signal. The higher the number, the better the signal. If the reading reaches full scale, you can adjust the 'ATT' to reduce the input signal. Continue moving the until you get the highest meter reading and the highest possible beep tone.
5. Disconnect the jumper cable and readings, then reconnect the LNB or LNBF with the receiver.

Packing List:
1 x Satellite Finder Meter
1 x Manual