Military Card size 2-5/8” x 3-7/8” x 10 mil thick on both sides heat activated laminating pouches for cards inserted up through 2-3/8” x 3-5/8” are high clarity after adhesive is heat activated. The clear glossy finish protects and enhances colors. These laminates are 10 mil thick on each flap for major durability, strength, rigidity and protection. ALERT: Many pouch laminators on the market can seal a maximum of only 5 mil pouches, so PLEASE make sure your laminator is capable of sealing 10 mil pouches prior to ordering. (If you don't have your machine's manual, a good reference is if your laminator has either a speed control OR a temperature control, it will likely seal 10 mil pouches).
Our laminating products provide high value protection using quality materials. This product has heat activated adhesive compatible in all thermal pouch laminators capable of sealing 10 Mil 2 sides, 2-5/8” x 3-7/8” laminating pouches.
Note: Industry standard specification for 10 mil laminating pouches is 10 mil on each flap for a total of 20 mil added to your paper sheet. 1 mil equals 1/1000th of an inch (metric: 25 microns). The industry calls these pouches, yet they are sealed on only one edge instead of three (like a folder, but with 3/32” flat seal for the fold).

FEATURES:
High glossy finish brightens colors dramatically
Waterproof and Resists Penetration by Chemicals, Greases, and Oils
Small Pre-Rounded Corners for a Safe Professional Finish
Metric Pouch size: 67mm x 98mm x 250 microns thick (x 2 sides = 500 microns total thickness added to your sheet)
Recommended Insert Sheet Size: Maximum 2-3/8” x 3-5/8” (60mm x 92mm) provides standard 1/8” (3mm) sealed border protecting your sheet's edges
Made of 2 Durable 10 mil polyester plastic sides including heat activated adhesive (20 mil total encapsulating and waterproofing your sheet) which becomes clear when heat and even pressure is applied (laminator recommended)

TYPICAL APPLICATIONS:Laminating as large as 2-3/8” x 3-5/8” sheets
Sale Tags
Flash Cards
Identification Cards
Proximity Access Cards for Security
Membership Cards
Badges

Laminating Tips:When trying ANY for the 1st time, consider running at a slightly lower temperature (or faster speed). If the results are cloudy, you can always run the sheet again at a higher temperature or slower speed, but you cannot fix heat blisters caused by running too hot.
If you plan on trimming or Hole punching sheets, wait 24 to 72 hours for adequate adhesive curing time and a professional cut edge.