Set of 2 forks seals and dust boots set for the Kawasaki models listed. When replacing fork seals be very careful not to scratch or gouge the aluminum during the removal of the old seals. Use a fork seal driver to install the new seals. Be sure to drive it in evenly and make sure it fully seats so the snap ring can be installed. If you're unsure if your forks are stock please check the fork seal dimensions. The old dust boots become stiff and start to crack over time, keep dirt and water off your fork seals with a fresh pair of boots!
These are high quality reproduction seals produced in Taiwan. When it comes to rubber parts and seals it's generally better to install a brand new part instead of using a NOS part which has hardened due to age.
Set of 2 forks seals and dust boots set for the Kawasaki models listed. When replacing fork seals be very careful not to scratch or gouge the aluminum during the removal of the old seals. Use a fork seal driver to install the new seals. Be sure to drive it in evenly and make sure it fully seats so the snap ring can be installed. If you're unsure if your forks are stock please check the fork seal dimensions. The old dust boots become stiff and start to crack over time, keep dirt and water off your fork seals with a fresh pair of boots!
These are high quality reproduction seals produced in Taiwan. When it comes to rubber parts and seals it's generally better to install a brand new part instead of using a NOS part which has hardened due to age.
Inner Diameter: 37mm
Outer Diameter: 50mm
Height: 11mm
Material: NBR (Nitrile)
Top Opening ID: 35.4mm (1.4")
Bottom Opening ID: 38.5mm (1.5")
Overall OD: 55mm (2.1")
Overall Height: 14mm (.5")
EX250F Ninja 250R - 2008-2009, 2011-2012
EX500 Ninja 500 - 1994-1995
EX500 Ninja 500R - 1998, 2000, 2002-2004, 2006-2008
