Remark: For the main and rod bearings of the Subaru engines, 2 variations existed. For the main bearings, the thrust washer is either located at the #3 position (middle) or the #5 position (bottom). For the rod bearings, the shaft/journal size is either 48mm or 52mm. This listing offers main bearing set with the thrust washers at #5 position and rod bearing set with 52mm journal size. Please check with your professional installer if you are unsure on which set your engine takes.

This item includes:

Full Gasket Set
Multi-layered steel (MLS) head gasket
Intake manifold gasket
Exhaust manifold gasket
Valve cover gasket
Viton valve stem seals
Camshaft seal
O-rings
Front crankshaft seal
Rear main seal
Water pump gasket
Other small gaskets
Gasket silicone sealant

Complete Pistons with Ring Set (Oversize 0.50mm = 0.020")
Compression Ratio: stock
Standard Diameter: 99.50mm + 0.50mm
1st Group: 1.20mm
2nd Group: 1.20mm
Oil Ring: 2.00mm

Engine Bearing Set (Standard Size)
Crankshaft Main Bearings - Standard
Connecting Rod Bearings - Standard

Timing Belt Kit
1 Timing Belt (281 teeth)
1 GMB Tensioner (bearing & hydraulic cylindrical integral)
1 GMB Upper Idlers (bearing)
1 GMB Lower Idler (bearing with inner flange)
1 GMB Lower Idler (sprocket with bearing)
1 GMB Upper Idler (small 31mm outside diameter)

Oil Pump

Water Pump

Part Numbers:
FS9013, MB8309, RB8296, PS9013-0.50mm, TBK328B, WP160-2040, OP9002, SL1000