The Soda Bottle Dispenser is made of environmentally friendly plastic, which is safe and sturdy; it uses a thickened leak-proof sealing ring, which has strong sealing, prevents air leakage and water leakage, ensuring a smooth and mess-free dispensing experience. The Soda Pop Dispenser comes with a thick, non-slip tripod that's heavy-duty, keeping it stable on any surface to prevent spills and accidents.

How to use:

ATTENTION: Make sure that the 2 white O-rings are sealed properly on the thread of the red holder before the installation.

① Install the beverage holder first
② Upside down install the holder to the beverage bottle mouth
③ Poke a hole in the bottom of a beverage bottle with the needle
④ To pour the drink, just move the handle

Warm tips:
1. When using it, first turn the product over, align the mouth of the base with the mouth of the beverage bottle, and tighten it firmly! Then flip the drink over and place it on the table for use!
2. If it is soda, you only need to pull the handle to get the drink! If there is no gas in the drink, you need to press the bottle with your hands to release the drink!
3. This product is suitable for carbonated drinks, after pouring half a bottle of Coke. The pressure inside the bottle will be relatively low. At this time, shake it gently and it can be used normally.