Please confirm the model before purchasing.
Bando Drive Belt 743-20-32

The outer circumference of this item measured by a flexible tape is approximately 760mm.

The second number 20 is nominal width.The actual width varies from 19.8mm to 19.9mm approximately if measured by vernier caliper ( it is not accurate due to manual measurement.)

The tooth height is approximately 9.7mm if measured by vernier caliper at natural status (Do not clamp drive belt too tightly when you measure by vernier caliper, or the data indicated will be a little lower than 9.7mm).

Please be noted that the tooth height of BANDO 743-20-32 (or 743-20-30) is higher than that of Gates Powerlink 743-20. If you need the lower tooth version, please buy our GATES Powerlink 743-20 drive belt (search by keywords "Gates 743 20").

ATTENTION:

The mark 743-20-32 on this drive belt is just a mark to distinguish one drive belt from another.
The first number 743 does not mean the outer circumference of this drive belt is 743mm.
The above statement on sizes is used to avoid possible dispute by a reason of " size not as described " due to misunderstanding.

Application:
GY6-125/150cc short-case 4 stroke scooters (left crankcase cover is about 410mm long).

If the size mark of your old drive belt is 743-20-32 or 743-20-30, our this drive belt can replace your old drive belt perfectly.

If your old drive belt does not have a size mark "743 20" or "743 20 30" or "743 20 32", please do NOT order this item
Our rubber timing belts are your ideal replacement belt.