You can create your own custom rustic pavers with Stone Master's Rustic Paver Mold. The rubber mold itself is 27 Long x 15" Wide x 2" Deep, weighs approximately 13.5 lbs, and produces one paver at approximately 24" Long x 12" Wide x 1.5" Deep. For foot traffic only, not recommended for driveways. Our molds require NO release agent. This will save you money, time, and clean up, as well as easy, clean release of face color pigments, unlike plastic molds, urethane molds, and silicone molds. This professional quality mold will last you for hundreds of pours with proper care! We recommend using a high strength concrete mix of at least 6000 psi compressive strength, such as Sakrete PRO-X180 which reaches 8000 psi at 28 days. Manufactured Stone Basic Mixing Procedures Using A Pre-bagged Concrete Mix for your Rustic Paver Mold: This is one suggestion for mixing the concrete for your paver mold. There are many other instructions available online, including videos. BE SURE TO USE A CONCRETE MIX THAT CONTAINS PORTLAND CEMENT. We recommend Sakrete PRO-X180 which reaches 8000 psi at 28 days. Follow the manufacturer's instructions for mixing. If using pigment, add desired iron oxide pigment to mixer (100% pure, no additives). These can easily be found on Amazon, etc. A plasticizer can be added to reduce the amount of water in the mix. Pour into the molds which may already have coloring additives… NO RELEASE AGENT NECESSARY. Vibrate molds to release air bubble. Finally, cure the concrete in the paver mold for approximately 24 hours at the minimum of 70 degrees Fahrenheit before demolding. Higher humidity is desired. Molds can be covered with a tarp to retain more heat and humidity. Continue to cure demolded stones a