Size: 0.73*0.63"(18.5*16mm); Input voltage: 3 - 10V; Single H bridge output current: 1.5A, can drive 2 DC geared motors
Built-in overcurrent protection, short circuit protection, undervoltage lockout and overtemperature protection. With low power sleep mode
The DC DRV8833CPWR Motor Drive Module Board can work with PWM inputs either directly from an Arduino, Raspberry Pi, Jetson Nano, or a PCA9685 driver board
For DIY projects like robots, RC vehicles, or motorized gadgets. It can drive DC motors up to 1.5A and 4-wire stepper motors. For better using, suggest to not go over 4V (1S LiPo) and run only 3V DC motors
Instructions for use:ULT low level is sleep mode (need to disconnect the J2 short solder joint behind the module). OUT1, 0UT2 is a 1-way H-bridge, and the corresponding control is IN1, IN2. OUT3, 0UT4 is the second H-bridge, and the corresponding control is IN3, IN4. EEP is the protection output and is not used by default. VCC is a voltage input of 3 to 10V. GND is grounded
1PCS DC 6-60V 400W BLDC Three-Phase Brushless Motor Controller PWM Hall Motor Control Driver Board 12V 24V 48V with Forward/Reverse/Stop/Brake Function
SAR 84
DC Motor Speed Controller - PWM 6V/12V/24V/28V/3A/80W Speed Adjustable Reversible Switch 1203BB DC Motor Driver for Fan, DC Motor, Fish Tank Oxygen Pumpt
SAR 35
-41%
Century formerly AO Smith GF2054 1/2 hp, 1725 RPM, 115 volts, 48/56 Frame, ODP, Sleeve Bearing Belt Drive Blower Motor
SAR 637
-5%
S97015162 Fan Motor Assembly Compatible with Broan NuTone Bathroom Exhaust Fans with 8" x 8-1/4" Housing, for 678-G/2678F-A, 683-C, 770RLTK, 676-D, 763N, 684-D Fans (110 CFM / 4 Sones)
SAR 233
