Brand new pressure transducer. Stainless steel body. Input: 0-2500 psi. Output: 0.5V – 4.5V linear voltage output. 0 psi outputs 0.5V, 1250 psi outputs 2.5V, 2500 psi outputs 4.5V. Works for oil, fuel, water or air pressure. Can be used in oil tank, gas tank, etc. Accuracy: within 1.5% of reading (full scale). Current draw: less than 4 mA. Burst (over or max pressure) pressure: minimum 3000 psi. Thread: 1/8”-27 NPT. (see our fitting set for other thread size below). Wiring connector: water sealed quick disconnect. Mating connector and wire harness (pigtail) is included. Wiring: Red for +5V. Black for ground. Blue for signal output. Our material is using top of line 316 stainless steel (not 304) and high temperature auto-graded plastic. This is a high quality pressure sender, with ceramic pressure chip sensor inside. Specs: www.intindustry.com/files/Pressure_transducer_specs.pdf