Search

Search

Home / ALMOCN / Temperature & Humidity
4pcs SHT31-D Temperature and Humidity Sensor Breakout Digital Output Temperature and Humidity Sensor Module IIC I2C Interface 3.3V GY-SHT31-D for Arduino in Saudi Arabia 4pcs SHT31-D Temperature and Humidity Sensor Breakout Digital Output Temperature and Humidity Sensor Module IIC I2C Interface 3.3V GY-SHT31-D for Arduino in Saudi Arabia 4pcs SHT31-D Temperature and Humidity Sensor Breakout Digital Output Temperature and Humidity Sensor Module IIC I2C Interface 3.3V GY-SHT31-D for Arduino in Saudi Arabia 4pcs SHT31-D Temperature and Humidity Sensor Breakout Digital Output Temperature and Humidity Sensor Module IIC I2C Interface 3.3V GY-SHT31-D for Arduino in Saudi Arabia 4pcs SHT31-D Temperature and Humidity Sensor Breakout Digital Output Temperature and Humidity Sensor Module IIC I2C Interface 3.3V GY-SHT31-D for Arduino in Saudi Arabia 4pcs SHT31-D Temperature and Humidity Sensor Breakout Digital Output Temperature and Humidity Sensor Module IIC I2C Interface 3.3V GY-SHT31-D for Arduino in Saudi Arabia 4pcs SHT31-D Temperature and Humidity Sensor Breakout Digital Output Temperature and Humidity Sensor Module IIC I2C Interface 3.3V GY-SHT31-D for Arduino in Saudi Arabia

4pcs SHT31-D Temperature and Humidity Sensor Breakout Digital Output Temperature and Humidity Sensor Module IIC I2C Interface 3.3V GY-SHT31-D for Arduino

SAR 84
Brand
ALMOCN
Weight
5 g
– 1 +

Special Features

  • SHT31-D Temperature/Humidity sensors are some of the finest & highest-accuracy devices you can get. And, finally we have some that have a true I2C interface for easy reading.
  • The SHT31-D sensor has an excellent ±2% relative humidity and ±0.3°C accuracy for most uses.
  • It also is 3V or 5V compliant, so you can power and communicate with it using just about any microcontroller or microcomputer.
  • Operating temperature range: -40° to 125°C (-40° to 257°F)
  • RH response time: 8 seconds (tau63%)

Description

Power Pins:
Vin - this is the power pin. The chip can use 2.5-5VDC for power. To power the board, give it the same power as the logic level of your microcontroller - e.g. for a 5V micro like for Arduino, use 5V. For a 3.3V controller like a Raspbery Pi, connect to 3.3V GND - common ground for power and logic
SCL - I2C clock pin, connect to your microcontrollers I2C clock line. This pin has a 10K pullup resistor to Vin
SDA - I2C data pin, connect to your microcontrollers I2C data line. This pin has a 10K pullup resistor to Vin
ADR - This is the I2C address selection pin. This pin has a 10K pull down resistor to make the default I2C address 0x44. You can tie this pin to Vin to make the address 0x45
RST - Hardware reset pint. Has a 10K pullup on it to make the chip active by default. Connect to ground to do a hardware reset!
ALR - Alert/Interrupt output. You can set up the sensor to alert you when an event has occured. Check the datasheet for how you can set up the alerts
Package Included:
4 * SHT31-D Temperature Humidity Sensor

Related Items

{"error":"Error","cart_limit":"You have too many items in your cart.","prod_limit":"You cannot add any more of this item"}