Package Includes:
4 *1/2-20 Flange Bolt
4*M12x1.25 Flange Bolt
4*3/8-24 Flange Bolt
2* Clamp Blocks
1* Puller Screw

Half-round yoke applications:
1. Remove nut and washer retaining yoke to the shaft.
2. Apply penetrating oil to the shaft splines and lubricate the tool Puller Screw.
3. Loosely attach the Clamp Blocks to the yoke with the appropriate Flange Bolts.
4. Slide the Puller Body through the Clamp Blocks, with the flats on the Puller Body towards the Yoke.
5. Thread the Puller Screw into the Puller Body until the tip of the Puller Screw lines up with the center of the shaft.
6. Tighten the Flange Bolts in the Clamp Blocks.
7. Use and impact wrench to turn the Puller Screw until the yoke is pulled from the shaft.

Full-round yoke applications:
1. Remove nut and washer retaining yoke to the shaft.
2. Apply penetrating oil to the shaft splines and lubricate the tool Pulling Screw.
3. Slide the Puller Body through the bearing cup bores until centered on the yoke.
4. Thread the Puller Screw into the Puller Body until it lines up with the center of the shaft.
5. Use and impact wrench to turn the Puller Screw until the yoke is pulled from the shaft.