All electronics ship with US style plugs.You may need a voltage converter or a plug adapter.
Special Features
1. Adding a gigabit Ethernet port can support some functions of ZEDBOARD+FMCOMMS2-3. The corresponding firmware is also provided in the documentation, but it does not support USB ports;
2. Add a JTAG port, which supports power supply, FPGA debugging, and serial port functions, making it convenient for some friends to develop bare metal drivers. In the factory firmware, this JTAG port is used as the boot information output interface, and also for configuring network port IP addresses and other functions.
3. Replace the main control chip, the original Pluto main control chip is XC7Z010-CLG225, changed to XC7Z020-CLG400; Increase DDR capacity to 1GB;
4. Introduce dual transmitter and dual receiver on the RF interface, and crack it into 9361 using the original firmware; Introduce several GPIO for users to expand their functions;
5. Strict simulation and impedance control of the RF part, adding PA to increase output power
120pcs Multicolored Jumper Wires for Prototyping Electronic Projects Arduino, ESP32, ESP8266, Raspberry Pi
SAR 37
Waveshare ESP32-S3 1.46inch Round Display Development Board, 412×412, Supports Wi-Fi & BLT, Accelerometer and Gyroscope Sensor, Onboard Speaker and Microphone, with Protective Cover Glass
SAR 209
3.2'' ESP32 Display Resistive Touchscreen with WiFi+BT, ST7789P3 Driver 240x320 TFT LCD SPI Screen Module for Arduino
SAR 89
Web-888 16bit ADC 62M Bandwidth DDC Circuit Board - Professional-Grade Programmable Development Board for Electronics & Engineering Projects
SAR 1,929
