101 Standard Actuator

5/16" (.79 cm) mounting hardware
Stroke: 2-1/4" (5.72 cm)
Length overall: 12-1/8" (30.80 cm)
Length pin to pin: 11-1/2" (29.21 cm)
Diameter (upper housing): 2-1/2" (6.35 cm)
Mounting hardware: 5/16" ( .79 cm) or Delrin Pin (Part #121)

Part # (Superseded #)
15061-001(101-3), 24 Volt w/6' (1.83 cm) cable with Deutsch connector & mounting hardware(replacement length)

Top cap gland seal sheaths the actuator cable outer jacket as well as both internal conductors for maximum waterproofing

Corrosion proof Vandar mounts

Stainless steel ram won't flex, even under extreme loads

Double O-ring for maximum protection

Ballscrew rotates freely on 12 ball bearings at both ends of its stroke so there's no need for complicated limit switches and clutches

Self-locking ballscrew locks into position and will not drift

Precision molded, powdered metal, high alloy gears provide high accuracy, high wear resistance, and high strength for long life

Tough, high-torque motor easily transfers 750 lbs

High-impact, ultraviolet resistant nylon 66, 50% glass fiber reinforced thermoplastic housing

Corrosion proof Vandar cap and mount, stands up to severe loads