All electronics ship with US style plugs.You may need a voltage converter or a plug adapter.
Special Features
3Pcs 500Ma Mini Solar Lipo Charger Board CN3065 Lithium Battery Charge Chip DIY Outdoor Charging Board Module
This is a super miniature solar Li-ion battery charger based on CN3065 (single Li-ion battery charge management chip).
This Solar charger provide you with the ability to get the most possible power out of your solar panel or other photovoltaic device and into a rechargable LiPo battery. Set-up is easy as well, just plug your solar panel into one side of the Solar charger and your battery into the other and you are good to start charging!
The output of the Solar Charger is intended to charge a single polymer lithium ion cell. The load should be connected in parallel with the battery. By default, the Solar charge comes set to a maximum charge current of 500mA with a maximum recommended input of 6V (minimum 4.4V). It's recommended that batteries not be charged at greater than their capacity rating.
5V SD Card Module to IDE3.5 40 Pin Disk Drive Adapter Board Riser Card Capacity Supports Up to 128GB SDXD Card ATA IDE Module
SAR 67
40khz 35W Ultrasonic Piezoelectric Cleaning Transducer Plate Electric Ceramic Sheet Module Board
SAR 32
6-60V 400W BLDC 3 Phase DC Brushless Motor Controller PWM Hall Motor Control
SAR 73
X9C104 Digital Potentiometer Module X9C104S 100 Digital Potentiometer to Adjust The Bridge Balance Module
SAR 37
