Specification:
Material: Plastic
Color: Black
Finish: Primered
Placement on Vehicle: Front
Fitment Type: Direct Replacement
Bumper Cut-outs: Fog Light Cut-out
With Tow Hook Cover Plate
For Models Without Park Assist Sensor Holes Only
Fit for the following vehicles:
For Focus Electric Hatchback 4-Door 2018
For Focus RS Hatchback 4-Door 2016-2018
For Focus S Sedan 4-Door 2015-2018
For Focus SE Appearance Hatchback 4-Door 2015
For Focus SE Appearance Sedan 4-Door 2015
For Focus SE Hatchback 4-Door 2015-2018
For Focus SE Sedan 4-Door 2015-2018
For Focus SEL Hatchback 4-Door 2017-2018
For Focus SEL Sedan 4-Door 2017-2018
For Focus Titanium Hatchback 4-Door 2015-2018
For Focus Titanium Plus Sedan 4-Door 2015
For Focus Titanium Sedan 4-Door 2015-2018
Package Included:
1 x Front Bumper Cover
Note:
The bumper cover may be folded for ease of transport, but this will not affect its performance and can be restored by heating
Outdoor Method:
1. Find a place in direct sunlight (up to 4 hours in the sun)
2. Open the package and take down the bumper cover
3. Place the cardboard package flat on the ground. This will serve as a clean surface for the bumper cover
4. Allow the bumper cover to sit in the sun for 3 hours
5. After the three hour mark is reached, reposition the bumper cover so that the front faces the floor. Leave it there for the remaining hour
Indoor method
1. Use the cardboard package as your work surface and place the bumper cover on it
2. Look for the crease area on the bumper cover. Heat these areas with a heat gun
3. Avoid pointing the heat gun at one location for a long time, as overheating can deform or melt the plastic. Keep the gun moving to spread the heat evenly over the surface of the bumper cover
4. After straightening the last piece of indented plastic, you can consider the bumper cover fully unfolded