Upgrades of NanoVNA-H Rev3.6
- Lower power noise, less noise when using harmonics
- 1300mAh battery for 6H continuous use
- 2.8” compact size
- Supports MicroSD card to save data (only SPI mode)
- RTC support
- Change the port names to Port 1 and Port 2
- More accurate reflection measurement
SPECIFICATION
-PCB: 2.1” x 3.4” (excluding protruding parts such as connector switch)
-ABS housing: 2.3” x 3.6” x 0.7” (excluding protruding parts)
-Measurement frequency: 10KHz~1.5GHz
-RF output:n0dbm (±2dB, fundamental)
-Frequency accuracy:
-Frequency stability:
-Measurement range: 70dB (50kHz-300MHz), 60dB (300M-900MHz), 40dB (0.9G-1.5GHz)
-Port SWR:
-Display: 2.8" TFT (320x240)
-USB interface: USB type-C
-Communication mode: CDC (serial)
-Power: USB 5V 130mA, built-in 1300mAh battery, max charging current of 300mA
-Number of calibration points: Max 101 (optional), unrestricted when connected to PC
-Number of scan points: Max 101 (optional), unrestricted when connected to PC
-Scan point speed: >400p/s (RBW=4000Hz)
-Display trace: 4, mark: 8, settings save: 5
PACKAGE
-1 x NavoVNA-H Vector Network Analyzer
-1 x USB Type-C Cable
-1 x 25cm Type-C to Type-C Cable
-2 x 20cm SMA male to male RG174 RF Cable
-1 x SMA Calibration Kit (Open/Short/Load)
-1 x SMA female to female Connector
-1 x Pick