🟢 Fits Baldor Tapered Spindle 3/8" Right
🟢 Fits Baldor Polishing Lathe
🟢 Tapered Spindle
🟢 Fits Baldor Lathe Motors

🟢 The spindle is made to use with a Baldor Polishing motor.
🟢 Spindle is fits 3/8" Polishing lathes has an inside diameter that is tapered to fit on the tapered shaft of a Baldor Polishing motor.
🟢 These are specifically made to fit Baldor motor shafts since they are not straight, but have a slight taper.
🟢 Spindles are a friction fit, they are pushed on to the shaft of the Baldor motor, to properly secure them onto the shaft, lightly tap with a soft mallet or a piece of wood.
🟢 To remove, just use the screw off spindle remover on the motor by simply unscrewing and turning it until the spindle is pushed off of the tapered shaft.
🟢 Spindles is made of cold rolled steel is machined to close tolerances, made in U.S.A.
🟢 Spindle has a 3/8" Tapered arbor hole to work on the Right Side of Baldor 3/8" shaft motors.
🟢 The spindle arbor hole has a slight tapered to fit and be held on the Baldor Motor Lathes Right Side shaft.
🟢 Note: Spindle does not have tightening screws.

🔻 SPECIFICATIONS: JETS Product # 1603-212370 🔻

🔸 Precision Quality
🔸 Machined - High Speed Lathe
🔸 Made from 3/4" Stock Material
🔸 Material: Cold Rolled Steel
🔸 Overall Length: 3-1/2" - 90mm
🔸 Spindle Body Length: 1-3/8" - 35mm
🔸 Spindle Tapered Length: 2" - 51mm
🔸 Arbor Hole: 3/8" Tapered Friction Grip to Shaft
🔸 Weight: 2.75oz.
🔸 Spindle is made to be used on a 3/8" tapered shaft diameter and on the Right-Hand Side of Motor with forward direction.