Filter, Regulator & Lubricator Combos
SKU: CH10931
Filter material: Cured paper
Part Number: CH10931
Height: 262mm
Outer diameter: 125mm
Inner diameter: 52mm
Origin: China
Applicable models: Generator sets are only equipped with replacement filters on FG, FH and MA models.
NOTE: Before installing a seal, be sure to clean the sealing of any dirt and debris.
1: Remove the T-handle and cover.
2: Using the filter bail, carefully remove the dirty filter by pulling upward in a twisting motion.
3: Install the filter onto the center tube and press down until it bottoms out.
4: Pour clean fuel into the filter cavity until it is full.
5: Remove the old cover gasket and replace with a one. Lubricate with clean fuel.
6: Reinstall the cover onto the housing.
7: Install T-handle O-ring onto T-handle as shown. Lubricate with clean fuel.
8: Reinstall the T-handle. Hand tighten only - do not use tools.
9: This repair kit is only suitable for FG, FH and MA models: FE and FF models require repair kit RK 11-1404.

==========
Type: Filter
Model: CH10929
Origin: Mainland China