Product Description:
Eastyupin Liquid Electrical Tape outperforms traditional electrical tapes in hard-to-reach areas such as plug bases, moisture-sensitive wires, and circuit board seals. Formulated with non-toxic, flame-retardant materials, it forms a flexible, waterproof seal that withstands high temperatures and electrical faults. Suitable for both indoor and outdoor use, it has an initial curing time of 4 hours and a full cure time of 24 hours, resulting in a durable, rubber-like insulating coating.
Product Name:
Eastyupin Liquid Electrical Tape.
Model: UNIVERSAL-YTJYJ-006.
Kit Contents: 2 x 2 fl oz liquid electrical insulating sealant.
2 x 400 grit sandpaper sheets.
1 x brush.
4 x PET gloves.
Instructions:
Ensure the circuit is disconnected before operation.Do not operate with live power.
1. Surface Preparation: Clean the wire/cable surface to remove dust, oil, or moisture. Lightly sand the insulation and rust/oxidized areas with 400 grit sandpaper to enhance adhesion.
2. (1) Wear PET or rubber gloves during construction, open the tube, and apply a thin and even coating directly to the repair area.
(2) Apply two thin layers (avoid accumulation/dripping), and wait 10-15 minutes between each layer to ensure complete coverage of the joint.
(3) Extend the joints on both sides by 10mm to achieve complete insulation.
3. Use the included brush to smooth any uneven areas.
4. Allow to air dry naturally at room temperature (68-77°F/20-25°C) to cure.
Avoid contact with water and dust during curing. Please wait 24 hours for complete curing before powering on.
Important safety precautions:
1. Never use in live circuits - always disconnect the power before construction.
2. Due to its fluid properties, apply a thin layer to prevent dripping. Wait 15 minutes for initial drying before applying the second layer.
3. Use the included sandpaper to lightly sand the wire insulation to create a textured surface and enhance adhesion.
4. After use, thoroughly clean the nozzle and reseal it to keep the tube clean. Safety Precautions:
1. Keep out of reach of children and pets. If it gets into eyes, rinse immediately with water and seek medical attention.
2. Avoid skin contact. This product is non-irritating, but if contact occurs, wash with soap and water.
3. Use in a well-ventilated area. Keep away from open flames.
4. Never use on live circuits – always disconnect the power before use.
Storage and Shelf Life:
Store in a cool, dry place (41-95°F/5-35°C). Shelf life: 18 months.