A holster that covers the trigger guard and nothing else. This one fits your S&W M&P SHIELD PLUS 3.1/4in (No WML). Every one is formed on our CNC-machined aluminum molds. The KYDEX picks up the mold surface exactly, which makes the inside glass smooth and easy on your gun's finish. How a trigger guard holster works The shell wraps the trigger guard only. There is no material covering the slide, so the whole gun sits closer to your body than a full holster allows. Retention is fixed and set by the mold, so it clicks on and holds until you pull the gun free. The holster stays on the belt when you draw. It is the smallest thing we make that still covers the trigger. Before you order, check two things Your gun and the fitment above need to be exactly the same model. Ordering the wrong one is the most common mistake we see, so read it against your gun, not from memory. Then check if you have a rail mounted light. No WML or Weapon Mounted Light unless the fitment names one. If it does, the shell is molded around the gun and light together and will not hold the gun without that light installed. Because the slide stays exposed, any optic, suppressor height sight or threaded barrel clears without a cut. What comes with it Right and left hand claws, both included, and a 1.5 inch tuckable belt clip. The holster itself is ambidextrous, so the same part works for either hand, and you can move it side to side without buying another one. Ride height sets standard or deep conceal, and cant adjusts with a Phillips screwdriver. Tuckable, so you can tuck in your shirt over the gun and inside the clip. When your new holster arrives The gun should seat with a firm click. Retention is fixed and does not adjustment. If it feels far too tight or too loose, most likely the wrong gun is being inserted. Specs: .08 inch KYDEX, ambidextrous, 1.5 inch tuckable belt clip, claws included, black oxide hardware, made in the USA.