This (2) pack heavy duty, single-mold cast body, quarter turn angle stop valve is the solution to a long lasting, dependable shut-off valve for residential and commercial washing machines that requires a 5/8 inch OD comp inlet x 3/4 inch male hose thread outlet. The chrome plated, lead free, single piece designed valve with nut and ferrule is made for long-lasting durability and heavy duty usage in potable and non-potable plumbing and water distribution systems.
Note to installer:
This heavy duty valve is machined and crafted with very high precision; leaks after installs are very rare. If leaks do occur, most likely it is due to an incorrect installation method. Follow this guidance during install:
- DO NOT reuse old compression ferrule and nut. Remember to remove existing ferrule and nut from previous valve as this may cause improper seal and potential catastrophic flood to the property.
- DO NOT overtighten the nut as this will deform the compression ring and cause a leak.
- DO NOT use on copper stub-out that has been deformed or has uneven surface.
Product Disclaimer:
P65 warning requires products sold in the State of California to display a warning label indicating any traces of chemicals known to the State to cause birth defects or other reproductive harm. Although this product is listed as "lead free/low lead", it only pertains to the material of the area where potable water runs through/touches. Other areas such as the handle may still have minute traces of metals/chemicals known to the State to cause birth defects or other reproductive harm and have to be disclosed per P65 Warning.